BINDER KB 23 - Manual (Page 20)

KB (E3.1 + E5.1) 11/2014 page 20/100
2.5 Unit rear
(13)
(14)
Figure 8: Unit rear with position of RS 422 interface
(13) Interface RS 422 for computer communication
(14) Power cable
3. Completeness of delivery, transportation, storage, and
installation
3.1 Unpacking, and checking equipment and completeness of delivery
After unpacking, please check the unit and its optional accessories, if any, based on the delivery receipt
for completeness and for transportation damage. Inform the carrier immediately if transportation damage
has occurred.
The final tests of the manufacturer may have caused traces of the shelves on the inner surfaces. This has
no impact on the function and performance of the unit.
Please remove any transportation protection devices and adhesives in/on the unit and on the doors and
remove the operating manuals and accessory equipment.
CAUTION
Sliding or tilting of the unit.
Damage to the unit.
Risk of injury by lifting heavy loads.
∅
Do NOT lift or transport the unit using the door, the handle, or the lower housing.
∅ Do NOT lift units size 720 by hand.
 Lift units size 23. 53 und 115 from the pallet with the aid of four people in the area of all
4 unit feet.
 Lift units size 240 from the pallet with the aid of six people in the area of all 4 unit feet
or use a fork lifter. Set the fork lifter only from the front or rear in the middle of the unit.
 Lift units size 720 using technical devices (fork lifter) from the pallet. Set the fork lifter
only from the front or rear in the middle of the unit.
∅ Do NOT set the fork lifter from the unit side.