Altera Phase-Locked Loop Reconfiguration IP Core - Manual (Page 11)

Design Example Page 11
Phase-Locked Loop Reconfiguration (ALTPLL_RECONFIG) Megafunction February 2012 Altera Corporation
6. In the MegaWizard Plug-In Manager pages, select or verify the configuration
settings listed in Table 2 . Click Next to advance from one page to the next.
Table 2. Configuration Settings for the ALTPLL Megafunction (Part 1 of 2)
MegaWizard Plug-In
Manager Page
Settings Value
2a
Megafunction Under the I/O category, select ALTPLL
Which device family will you be using? Stratix
Which type of output file do you want to
create?
VHDL
What name do you want for the output file? reconfig_pll
Return to this page for another create
operation
Turned on
Parameter Settings
(General/Modes)
Currently selected device family Stratix
Match project/default Turned on
Which device speed grade will you be
using?
Any
What is the frequency of inclk0 input 100 MHz
Which PLL type will you be using? Enhanced PLL
How will the PLL outputs be generated?
Select Use the feedback path inside the PLL.
Select In normal mode
Which output clock will be compensated
for?
c0
Parameter Settings
(Scan/Inputs/Lock)
Create optional inputs for dynamic
reconfiguration
Turned on
Long chain: All 6 core and 4 external clocks
are available
Selected
Create an ‘pllena’ input to selectively enable
the PLL
Turned off
Create an ‘areset’ input to asynchronously
reset the PLL
Turned on
Create an ‘pfdena’ input to selectively
enable the phase/frequency detector
Turned off
Create ‘locked’ output Turned on
Create output file(s) using ‘Advanced’ PLL
parameters
Turned off
Output Clocks
(clk c0)
Use this clock Turned on
Enter output clock frequency 100 MHz
Clock phase shift 0 degrees
Clock duty cycle (%) 50
Create a clock enable input Turned off
EDA Generate netlist Turned off