Pilz PMCprimo DriveP.01/AA0/4/0/0/208-480VAC - Manual (Page 77)

Commissioning
Operating Manual PMCprotego S1­2(­C)
1002528­EN­02 77
7.3.3.2 Download configuration to SD card
2 5
You can download the configuration data to the safety card via an SD card. The con­
figuration data must first be saved to the SD card.
There are two options for downloading a configuration to an SD card:
1. option 2 : Downloading a configuration via an SD card, which is written by the PC.
Prerequisite:
a Connection to an external SD card read device
Procedure:
– Select Project ­> Save to SD Card in the safety card's Configurator.
– Remove the SD card from the external SD card read device and insert it into the
servo amplifier's SD card read device
3
(continue as described under "Download
configuration from SD card to safety card").
2. option 5 : Downloading a configuration via an SD card, which is written by the servo
amplifier.
Prerequisite
– Connection is established between the PC and servo amplifier (RS 232 or Ether­
net).
– An SD card must be inserted in the servo amplifier.
Procedure:
– Select Online Mode ­> Servo Amplifier Configuration ­> SD Card in the safety card's
Configurator.
– Remove the SD card from the servo amplifier and insert it into the SD card read
device of the servo amplifier that you wish to configure 6 (continue as described
under "Download configuration from SD card to safety card").
INFORMATION
Further information is available in the safety card Configurator's online help.