Pilz PNOZ mm0.2p - Manual (Page 28)

6.2 Preparing for operation
6 Commissioning
Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]
6-4
6.2.3.2 Load project via USB port
Load project via USB port 6- Verdrahtung_mini_multi_Basis_Betr_erstes_Mal_USB_BA
Procedure:
 Insert a chip card into the card slot on the base unit.
 Connect the computer containing the PNOZmulti Configurator to the
base unit via the USB port.
 Switch on the supply voltage.
 Download the project (see PNOZmulti Configurator's online help).
 Once the project has been successfully downloaded, the status of the
inputs and outputs and the supply voltage will be shown on the dis-
play. The "RUN" LED will be lit.
6.2.4 Connection
Connection 6- Betriebsbereitschaft_herstellen_multi-mini Basisgerät
 Supply voltage
Supply voltage AC DC
For the safety system
For the semiconductor outputs
Must always be present, even if the
semiconductor outputs are not used
A1 + 24 V DC
A2 0 V
24 V + 24 V DC
0 V 0 V