Pilz PNOZ mm0.2p - Manual (Page 22)

5.2 Connecting the base unit and expansion modules
5 Installation
Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]
5-2
5.2 Connecting the base unit and expansion modules 5200 Connecting the base unit and expansion modules 5- Montage_multi_Basis_Verweis_Systemausbau
Please refer to the document "System Expansion" for details of the
number of modules that can be connected to the base unit and the mod-
ule types.
Montage_multi_Mini_verbind_mit_Modul_BA
The modules are linked via jumpers.
 Remove the terminator on the side of the base unit and on the expan-
sion module.
 Before installing the units on the mounting rail, connect the base unit
to the expansion module using the jumper supplied .
 Fit the appropriate terminator to the unconnected interfaces on the
base unit and expansion module.
– Left-hand side on the base unit and expansion modules to the left
of the base unit: Black/yellow terminator
– Right-hand side on the base unit and expansion modules to the
right of the base unit: Yellow terminator
Verdrahtung_multi_Achtung_Kabel_spannungsl_ziehen_Basis_u_Modul
CAUTION!
Only connect the base unit and expansion modules when the
supply voltage is switched off.
Terminator
Left
Terminator
Right
IM0 IM1 IM2 I6 I5 I4 IM3 I7
I8 I10 I14 I13 I12 I11 I15
X3
X1
X4
X2
PNOZ mm0.1p
T0 T1 T2 O2 O1 O0 T3 O3
IM16 IM17 IM18 0 V A2 A1 IM19 24 V
M20 M21 M22 M23
Jumper