Pilz PNOZ mm0.2p - Manual (Page 26)

6.2 Preparing for operation
6 Commissioning
Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]
6-2
6.2 Preparing for operation 6200 Preparing for operation 6-
6.2.1 Function test during commissioning
Function test during commissioning 6- Verdrahtung_multi_Basis_Betr_Funktionstest_BA
6.2.2 Using the chip card
Using the chip card 6- Inbetriebnahme_Chipkarte_einsetzen_1_wichtig_Kontaktflaeche_sauber
Inbetriebnahme_Chipkarte_einsetzen_2_wichtig_produkt_ausschalten
Inbetriebnahme_Chipkarte_einsetzen_3_Chipkarte_nicht verkantet
Make sure that you do not bend the chip card as you insert it into the
chip card slot.
Inbetriebnahme_Chipkarte_einsetzen_4_Chipkarte_nicht verkantet_Bild_multi_mini
CAUTION!
It is essential to check that the safety devices operate correctly
 after the chip card has been exchanged
 after a project has been downloaded
 when the project has been deleted from the base unit's mem-
ory ("Reset Project" menu)
NOTICE
The chip card contact is only guaranteed if the contact surface is
clean and undamaged. For this reason please protect the chip
card's contact surface from
 Contamination
 Contact
 Mechanical impact, such as scratches.
NOTICE
Switch off the product before inserting or exchanging the chip
card.