EXFO FTB-8500 Series for FTB-500 - Manual (Page 87)

Creating and Starting a Test Case
Ethernet and Fibre Channel Application 73
EtherSAM (Y.1564) Test Case
2. Port configuration:
2a. Select the port Connector
Type (Optical or
Electrical RJ-45). Optical is automatically selected for the
Ethernet 10G interface.
2b. For FTB-8510B, select the
port number by pressing
on Port 1 or Port 2.
2c. For Electrical RJ-45, if
required, select the Ethernet port
crossover check box to inverse the
pin-to-pair assignment of the UTP cable used.
Note: At this point you should have a link up indicated in the Tree view tab. A
green LED indicates a link up while a red LED indicates a link down. For
electrical port, if the link is down, make sure that the Ethernet port
crossover setting is correct.
2d. Press Next.