EXFO FTB-8500 Series for FTB-500 - Manual (Page 141)

Summary Tabs
Ethernet and Fibre Channel Application 127
Alarm Summary

Test
Global: Indicates the presence of any alarms/errors related to the test
such as Port, WIS, Ethernet, Pattern, High Layer Protocol, Fibre
Channel, and Other. Fibre Channel is not available with FTB-8510G.
Log Full: Indicates that the logger exceeds it maximum capacity of
5000 events.

Port: Indicates the presence of any alarms/errors related to the
physical port such as LOS, Frequency, and LOC (Ethernet 10G WAN
and FC 10x). Also indicates port power measurement Pwr (dBm) for
optical port, frequency Freq (bps), and Offset (ppm) for all interfaces
at the exception of 10 Mbps.

WIS: Indicates the presence of any alarms/errors related to Ethernet
10G WAN testing such as Section/RS (B1, LOF or SEF), Line/MS (B2,
REI-L, AIS-L, or RDI-L), High Order Path (B3, REI-P, AIS-P, RDI-P,
LCD-P, LOP-P, PLM-P, UNEQ-P, ERDI-PSD, ERDI-PCD, or ERDI-PPD),
and WIS Link. WIS is not available with FTB-8510B.

Ethernet: Indicates the presence of any alarms/errors related to
Ethernet testing such as Errors (FCS, Jabber, Runt, Oversize when
enabled (refer to Oversize Monitoring on page 163), Undersize, Idle,
Symbol, Collisions, Alignment, False Carrier, Block Error,
Out-of-sequence, or Frame Loss), Link, and Fault.. Idle, Symbol,
Collisions, Alignment, and False Carrier are not available with
FTB-8510G. Block Error and Fault are not available with FTB-8510B.

Fibre Channel: Indicates the presence of any alarms/errors related to
the Fibre Channel testing such as Errors (FCS, Oversize, Undersize,
Symbol for 1x/2x/4x, or Block for 10x), Link, and Fault for 10x. Not
available with FTB-8510G.