EXFO FTB-8500 Series for FTB-500 - Manual (Page 117)

Creating and Starting a Test Case
Ethernet and Fibre Channel Application 103
Ethernet Frame Analyzer Test Case
3. Optical configuration for Ethernet 10G interface only:
3a. Select the Transceiver Mode Choices
are Local Area Network (LAN) for
regular Ethernet interface
(10.31250Gb/s) and Wide Area Network
(WAN) for Ethernet stream
encapsulated inside a SONET/SDH frame structure (9.95328Gb/s).
Choices availability depend on the unit model and options refer to
Software Options on page 378 for more information.
3b. Select the source Clock Mode (WAN transceiver mode only).
Refer to Clock Synchronization on page 383 for more information.
3c. Press Next.
3d. Enter the J0 Trace and J1 Trace
messages (WAN transceiver mode
only). Refer to WIS TX on page 241 for
more information.
3e. Press Next.
4. Framing configuration:
4a. Set the Auto-Negotiation, Speed,
Duplex, and Flow Control parameters.
Not available with Ethernet 10G. Refer
to Interface Setup (Ethernet) on
page 140 for more information.
4b. Set the IP Version (IPv4 or IPv6). IP
Version is only available when the IPv6
software option (SK-IPV6) is enabled.