EXFO FTB-8500 Series for FTB-500 - Manual (Page 86)

Creating and Starting a Test Case
72 FTB-8500 Series and FTB-8120NGE/8130NGE
EtherSAM (Y.1564) Test Case
To create an EtherSAM (Y.1564) test case:
1. Test configuration:
1a. Select Ethernet 10/100/1000 or
Ethernet 10G as the Interface Type.
Interface Type is not available with
FTB-8510G.
1b. Select Single Port as the Topology.
Topology is only available with
FTB-8510B.
1c. Select the source Clock Mode.
Available with FTB-8510G only. Refer to
Clock Synchronization on page 383 for
more information.
1d. Select EtherSAM (Y.1564) as the Application Type.
1e. Select the desired EtherSAM sub test(s). All EtherSAM sub tests
are selected by default. Refer to Overview (Configuration) on
page 324 and Services (Configuration) on page 329 for more
information.
Service Configuration Test consists in sequentially testing each
service. It validates that the service is properly provisioned and
that all specific KPIs or SLA parameters are met.
Service Performance Test simultaneously validates the quality of
all the services over time.
1f. Leave the Dual Test Set check box cleared. For Dual Test Set test
case, refer to Ethernet EtherSAM (Y.1564) and RFC 2544 Dual Test
Set Test Cases on page 78.
1g. Press Next.