EXFO FTB-8500 Series for FTB-500 - Manual (Page 129)

Creating and Starting a Test Case
Ethernet and Fibre Channel Application 115
Fibre Channel BERT Test Case
2. Port configuration:
2a. For FTB-8510B, select the
port number by pressing
on Port 1 or Port 2.
For FTB-8510B in Dual
Ports, select the first port
and proceed with the rest
of the configuration for the
first port. However, before
pressing Finish, press
Back several times to
return to the port setup
window, select the second
port and proceed with the
rest of the configuration for the second port.
Select the Fibre Channel speed.
Choices are 1X, 2X for
FTB-8510B/FTB-8525/FTB-8120NGE,
and 1X, 2X, 4X, and 10X for
FTB-8535/FTB-8130NGE.
2b. Select the PSP check box when a series of handshakes (status
machine) is necessary to have a link up status. When the PSP
check box is cleared, no handshaking is done and only bit
synchronization is necessary to have a link up status. The PSP
(Link Protocol) check box is selected by default.
Link indicates the link status at the input port of the Fibre Channel
interface. A green LED indicates a link up while a grey LED indicates a
link down or disabled. The Tree view also displays respectively Link
up in green or Link down in red.
2c. Press Next.