EXFO FTB-8500 Series for FTB-500 - Manual (Page 55)

Introducing the Smart User Interface
Ethernet and Fibre Channel Application 41
Main Window
Exit

For FTB-8510B, FTB-8510G, FTB-8525, and FTB-8535:
The exit button ( X ) closes the current application. If a test is created,
one of the following confirmation messages is displayed, based on the
standalone feature status (enabled or not). Refer to the FTB-500 user
guide for more information on the standalone feature.

The following message is displayed when exiting the SUI while a
test is created and standalone is disabled:
Are you sure you want to exit the Ethernet and Fibre Channel
Application? Any unsaved information will be lost.

The following message is displayed when exiting the SUI while a
test is created and standalone is enabled:
Exiting the application will maintain the module alive as the
Standalone mode is enabled. Are you sure you want to exit?

For FTB-8120NGE, and FTB-8130NGE:
The exit button ( X ) switches from the current application to the
Network Analyzer application. If the test is running, a user
confirmation is required to stop the test before switching the
application. The switching puts the application in idle mode meaning
that the test case configuration is kept and will be recovered when
returning to that application.