EXFO FTB-8500 Series for FTB-500 - Manual (Page 116)

Creating and Starting a Test Case
102 FTB-8500 Series and FTB-8120NGE/8130NGE
Ethernet Frame Analyzer Test Case
2. Port configuration:
2a. Select the port Connector
Type (Optical or
Electrical RJ-45). Optical is automatically selected for the
Ethernet 10G interface.
2b. For FTB-8510B, select the
port number by pressing
on Port 1 or Port 2.
Port 1 (FTB-8510B only) is
automatically selected
when IPTV is selected.
For FTB-8510B in Dual
Ports, select the first port
and proceed with the rest
of the configuration for the
first port. However, before
pressing Finish, press
Back several times to return to the port setup window, select the
second port and proceed with the rest of the configuration for the
second port.
2c. For Electrical RJ-45, if required, select
the Ethernet port crossover check box
to inverse the pin-to-pair assignment of
the UTP cable used.
Note: At this point you should have a link up indicated in the Tree view tab. A
green LED indicates a link up while a red LED indicates a link down. For
electrical port, if the link is down, make sure that the Ethernet port
crossover setting is correct.
2d. Press Next.