Ditch Witch JT25 - Manual (Page 24)

JT25 Operator’s Manual
Controls - 23
Set-Up Console
2. Rear hood switch To open rear hood, press left
side of switch.
To close rear hood, press
right side of switch.
3. Cold start wait indicator Lights when intake air pre-
heater is operating.
Wait until light goes off before
starting engine.
NOTICE: If indicator is on, wait until it
goes out before starting engine.
IMPORTANT: If ignition switch is
turned to start position before
indicator goes out, the system will be
disabled and must be reset.
To reset, turn ignition switch to STOP,
then to run.
4. Ignition switch To start engine, insert key and
turn clockwise.
To stop engine, turn key
counterclockwise.
IMPORTANT:
• Restart engine with ignition switch
after it has been turned off with
tethered control remote engine
stop switch.
• If wrenches are engaged when
engine is stopped with ignition
switch, wrenches will release and
then engage when unit is started.
5. Right track switch To move forward, press top.
To move backward, press
bottom.
IMPORTANT: Use track switches only
if tethered control is inoperable.
Item Description Notes
c00ic148h.eps