Ditch Witch JT25 - Manual (Page 123)

Systems and Equipment - 122
JT25 Operator’s Manual
Tracker Control
CMW
Operation
Enable Thrust and Rotation
1. Start drilling unit.
2. Ensure that tracking unit is paired to tracking
display and enable tracker control. See
tracking system operator’s manual for
instructions.
3. Remove tracker control key (shown) from set-
up console at rear of drilling unit. Keep in
tracker operator’s possession.
4. Drill and track bore.
Troubleshooting Tip: If thrust and rotation are not enabled:
• Check whether the green tracker control
light (shown), located on drilling unit
anchoring console, is on. If it is,
communication has probably stopped
between tracker and display, or tracker is
set to incorrect code.
• If communication cannot be restored, install
tracker control key in drilling unit and rotate
clockwise. Green tracker control light will
go off. Thrust and rotation will function.
NOTICE: Tracker operator cannot disable
thrust and rotation from tracker if tracker control
key is installed in drilling unit and turned to the
disable position.