Ditch Witch JT25 - Manual (Page 192)

JT25 Operator’s Manual
Service - 191
As Needed
CMW
Replace SaverLok
Replace SaverLok (2) as needed. See your Ditch Witch dealer for replacement parts.
To remove:
1. Position Install SaverLok collar (3) over
SaverLok (2).
2. Start unit and position carriage so that collar
can be clamped in the rear wrenches but front
wrenches will not clamp on the nose of the
SaverLok.
3. Clamp wrench on collar and close both front
and rear wrenches.
4. Rotate spindle counterclockwise to unthread collar. Remove collar from system and set aside for later
use.
5. Remove SaverLok from SaverLok connection (1). This can be done by hand if the parts are clean and
dry. If the parts are not clean and dry, reposition carriage to clamp SaverLok in rear wrench and thrust
carriageback to pull SaverLok free from connection.
6. Turn off engine.
NOTICE: Clamping front wrench on
SaverLok nose will damage the threads and
impede disassembly.
IMPORTANT: Unit may not build enough torque to break out the SaverLok unless both wrenches
are close.