Ditch Witch JT25 - Manual (Page 151)

Systems and Equipment - 150
JT25 Operator’s Manual
Diagnostic Codes
CMW
Review Modes
Diagnostic Code Interpretation
Diagnostic codes are displayed through a series of light flashes and pauses. Count number of flashes and
pauses to interpret code.
Example: “Flash, flash, flash, pause, flash, flash, longer pause” represents code 32.
Tips for interpreting codes:
• In View All Codes mode, the green control cycle light will come on the first time the red diagnostic light
flashes a code. The green control cycle light will then go off and the red diagnostic light will flash the
code two more times.
• Codes are displayed from lower to higher numbers.
• Only numbers 1-5 are used in codes.
• Code 11 is not used.
• Code 12 signals successful entry into and exit from review mode.
IMPORTANT: Do not turn off ignition. Diagnostic codes are cleared each time ignition is turned off.
View All Codes View Codes Individually
1. Ensure that engine is running and no one is
sitting in operator’s seat.
2. Press and hold RESUME for two seconds.
3. Diagnostic light will flash code 12 (flash,
pause, flash, flash, longer pause) to indicate
review mode is operational.
4. After flashing code 12, all diagnostic codes
detected since the last time the ignition was
turned on are flashed three times each.
5. To save diagnostic codes, continue normal
operation. Do not turn ignition off.
6. Once the problem has been corrected, clear
all codes by turning ignition off.
1. Ensure that engine is running and no one is
sitting in operator’s seat.
2. Press and hold SET for two seconds.
3. Diagnostic light will flash code 12 (flash,
pause, flash, flash, longer pause) to indicate
review mode is operational.
4. After code 12 is flashed,
• Press RESUME to see same code again
or press SET to see next code.
• Continue pressing SET until all diagnostic
codes detected since the last time the
ignition was turned on are flashed. Cycle
is complete when code 12 flashes again.
5. To save diagnostic codes, continue normal
operation. Do not turn ignition off.
6. Once the problem has been corrected, clear
all codes by turning ignition off.