Ditch Witch JT25 - Manual (Page 111)

Systems and Equipment - 110
JT25 Operator’s Manual
Anchor System
CMW
Drive Anchors
1. Press top of anchor enable switch.
2. Raise anchor shaft to top of anchor frame.
3. Use high speed rotation and low thrust
speed to start driving anchor into ground.
4. Stop rotation and carefully position cap (1)
into centering tube (2). Continue rotation
and drive anchor into the ground.
5. Anchor is set when auger shaft flange (3)
rests firmly on cap (1) and centering tube
(2).
6. Repeat process for other anchor.
7. Leave anchors attached to anchor
drivers.
Remove Anchors
1. Use anchor rotation and thrust controls to slowly remove anchor shaft from ground.
2. Repeat process for other anchor.
NOTICE: Centering cap MUST be
positioned in centering tube to
prevent damage to anchor.