D-Link DI-206 User Manual
Page 74

DI-206 ISDN Remote Router
62
Configuration and
Management
•
Compression – Enables or disables Stac compression. This is an
industry standard using a 4:1 compression scheme. When enabled,
the router will try to use Stac compression on the designated ISDN
port whenever possible. If the destination device is not capable of
using Stac compression, the two devices will still communicate,
albeit without using Stac compression. When disabled, Stac
compression will never be used on this port.
•
State – Enables or disables this Remote Network Profile.
Select Connect Test at the bottom of the screen to test if your setup is
correct.
DHCP Configuration
The DI-206 Router implements the Dynamic Host Configuration
Protocol (DHCP), which allows the entire IP network to be centrally
managed by the router. It does this by assigning IP addresses and
configuration parameters to hosts as they are powered on and come
onto the network. This can be a great help for network administration
since many administrative tasks such as keeping track of each
computer’s IP address are handled by the router. The DI-206 can
implement DHCP in one of the two ways shown below: