D-Link DI-206 - Manual (Page 128)

DI-206 ISDN Remote Router
116 Configuration and
Management
•
Tx Error Packets – The number of invalid packets transmitted by
the router. This hardware counter shows the sum of Collisions,
Abort and Underrun packets.
•
Tx Underrun Packets – Runt packets. This counter shows the
number of packets transmitted by the router that are less than the
allowed 64 octets minimum length. Underrun packets occur due to
jam signals generated by collisions, backpressure, etc.
•
Tx Lost CTS Packets – The number of Clear To Send packets
that were lost by the router.
•
Rx Packets – The total number of packets received by the router.
•
Rx Bytes – The total number of bytes contained in packets
received by the router.
•
Rx Unknown Packets – The number of packets received by the
router that were of an unsupported protocol.
•
Rx Discard Packets – The number of packets dropped by the
router.
•
Rx Error Packets – The number of invalid packets received by the
router. This hardware counter shows the sum of NOA, Abort,
CRC, Overrun, CD Lost, Framing and Parity error packets.
•
Rx NOA Packets – Non-Octet Alignment. This counts the number
of packets received by the router that did not end on a byte
boundary. The receipt of a misaligned packet will generate a single
NOA event regardless of the number of misaligned octets in the
packet.
•
Rx Abort Packet – The number of packets that were dropped due
to user generated breaks in the transmission that occurred while a
packet is being received.