Connecting optional eouipment-^d, Video/aux jacks, When connecting a turntable – Aiwa NSX-V72 User Manual
Page 56: Line out jacks, Cd digital out jack (nsx-v72 only), Super woofer i] jack, Listening to external sources, 1 press the video/aux button, 2 play the connected equipment, To change a source name in the display
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
OTHER CONNECTIONS
MW—
CD DIGITAL OUT
(OPTICAL)
POWFR
CONNECTING OPTIONAL
EOUIPMENT-^
d
Refer to the operating Instructions of the connected equipment for
details.
• The connecting cords are not supplied. Obtain the necessary
connecting cords.
• Consult your local Aiwa dealer for adequate optional equipment.
VIDEO/AUX JACKS
This unit can input the sound signal through the jacks.
Use a cable with RCA phono plugs to connect an audio equipment
(turntables, LD players with analog output jacks, VCRs, etc.).
Connect the red plug to the R jack, and the whilte plug to the L jack.
When connecting a turntable
Use an Aiwa turntable equipped with a built-in equalizer amplifier.
LINE OUT JACKS
This unit can output the sound signal through the jacks.
Use a cable with RCA phono plugs to connect an audio equipment
with the LINE IN (analog input) jacks.
CD DIGITAL OUT JACK (NSX-V72 only)
This unit can output CD digital sound signals through the jack.
Use an optical cable to connect a digital audio equipment (digital
amplifier, DAT decks, MD recorders, etc.).
Remove the dust cap (a) from the CD DIGITAL OUT (OPTICAL)
jack.
When the CD DIGITAL OUT (OPTICAL) jack is not being
used
Attach the supplied dust cap.
SUPER WOOFER i] JACK
Connect an optional powered sub woofer with a built-in-amplifier to
the jack.
VlDEOAUXl
'—
J
i ^
'
‘ I
I i /
f/
J_ Jj
/__/
ij
n
%
LISTENING TO EXTERNAL
SOURCES
To play equbment connected to the VIDEO/AUX jacks, proceed as
follows. -► ID
1 Press the VIDEO/AUX button.
VIDEO appears on the display.
2 Play the connected equipment.
To change a source name in the display
When the VIDEO/AUX button is pressed, VIDEO is displayed initially.
It can be changed to AUX or TV.
With the power on, press the POWER button while pressing the
VIDEO/AUX button.
Repeat the procedure to select one of the names.
To adjust the sound level of the external source -r 0
When the sound level of the external source is much higher or much
lower than that of other function sources, adjust it as follows.
1 Press the VIDEO/AUX button and play the equipment.
2 Turn the VIDEO/AUX INPUT LEVEL control on the rear panel
until the sound level becomes the same as that of other function
sources.
56