Aiwa NSX-V72 - Manual (Page 32)

TAPE PLAYBACK
BASIC OPERATIONS
TAPE. —
DECK 1/2
REV MODE
J
►►
MUSIC SENSOR
If there is a 4-second or longer blank between each track, the
search for the beginning of the current or next track during
playback can be easily made.
When the ► of the button is illuminated, press the ►►
button to move to the next track or the ◄◄ button to move to the
beginning of the current track.
When the of the button is illuminated, press the
button to move to the next track, or the ►► button to move to
the beginning of the current track.
The search function uses a music sensor that may not be able
to detect tracks for tapes with:
• blanks of less than 4 seconds between tracks.
• noisy blanks.
• long passages of low-end sound.
• low overall recording levels.
CONTINUOUS PLAY
Affer playback on one deck finishes, the tape in the other deck
will start to play without interruption.
1 Insert tapes into decks 1 and 2.
2 Press the TAPE/DECK1/2 button to select the
deck to be played back first.
3 Press the REV MODE button to select
4 Press the button to start playback.
Playback continues until the ■ button is pressed.
About cassette tapes
• To prevent accidental erasure, break off the plastic tabs on
the cassette tape after recording with a screwdriver or other
pointed tool. -► H
@ Side A/® Tab for side A
To record on the tape again, cover the tab openings with
cellophane tape, etc. (On CrOa tapes, take care not to cover
the CrOa tape detection slot ©.)
• 120-minute or longer tapes are extremely thin and easily
deformed or damaged. They are not recommended.
• Take up any slack In the tape with a pencil or similar tool before
use. Slack tape may break or jam in the mechanism.
m
DOLBY NR system
The Dolby Noise Reduction system reduces tape hiss noise.
For optimum performance when playing back a tape recorded
with the DOLBY NR system, turn on the DOLBY NR system.
32