Dubbing the tape manually, Preparation, 1 press the tape button – Aiwa NSX-V72 User Manual
Page 36: 4 press the tape/deck 1/2 button to select deck, To stop dubbing, To erase a recording
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
RECORDING
CZ.» '
D
iczSali
C=IC=J rrrij
zmnri ttX4l
------
•
t M »IcZGil
•
J
1
® ® 0 0
3-
1
DECK 1/2
J
DOLBY NR
!}
DECK 1 2
I 1
Y
il n u n
U tj u U
” D n r /
REC REC MUTE
J
IRECORDI
U U IJ
DUBBING THE TAPE MANUALLY
Preparation
• Wind up the tape to the point where recording will start.
• Note that recording will be completed on one side of the tape
oniy.
1 Press the TAPE button.
2 Insert the original tape into deck 1 and the tape
to be recorded on into deck 2.
Insert each tape with the side to be played back or recorded
first facing the foreground.
3 Press the DOLBY NR button to turn off the Dolby
NR.
□□ NR on the display goes out.
4 Press the TAPE/DECK 1/2 button to select deck
1
.
5 Press the • REC/REC MUTE button to start
recording.
Playing and recording start simultaneously.
To stop dubbing
Press the ■ button.
To set the Dolby NR when playing back the dubbed tape
Press the DOLBY NR button and turn Dolby NR on or off to
match the original tape.
To erase a recording
Make sure the microphone is not connected to this unit.
1 Insert the tape to be erased into deck 2 and press the TAPE/
DECK 1/2 button to display TAPE 2.
2 Wind up the tape to the point where the erasure is to be
started.
3 Set the reverse mode by pressing the REV MODE button.
4 Press the • REC/REC MUTE button to start the erasure.
36