Aiwa NSX-V72 - Manual (Page 40)

RECORDING
3
4
5
Al EDIT RECORDING
The Al EDIT function enables CD recording without worrying
about tape length and track length. When a CD is inserted, the
unit automatically calculates track lengths. If necessary, the order
of tracks Is rearranged so that no track is cut short.
Al EDIT recording will not start from a point halfway into the
tape. The tape must be recorded from the beginning of either
side.
Use the remote control from steps 3 to 6.
1 Insert the tape into deck 2, and press the DOLBY
NR button to turn Dolby NR on or off.
Insert the tape with the side to be recorded first facing the
foreground.
2 Press the CD button and load the disc(s).
3 Press the EDIT/CHECK button once.
“EDIT” lights up and “Al” flashes on the display.
Each time it is pressed, the display changes.
• Al EDIT—► PRGM EDIT
c
4 Press one of the DISC DIRECT PLAY buttons to
select a disc.
5 Press the numeric buttons on the remote control
to designate the tape length.
10 to 99 minutes can be specified.
Example: When using a 60-minute tape, press the 6 and 0
buttons.
In a few seconds, the microcomputer determines the tracks
to be recorded on each side of the tape.
DISPLAY
(D
Tape length
® Tape side A (front side) (D
Remaining time of side A
© Selected tracks for side A
6 First press the #70 REC/REC MUTE button and
then press the <>■ button within 2 seconds to
start recording.
The tape is rewound to the beginning of the front side, the
lead segment is played through for 10 seconds, and then
recording starts. After recording on the front (side A) ends,
recording on the back (side B) starts.
To stop recording
Press the ■ button. Recording and CD play stop simultaneously.
To clear the edit program
Press the ■ CLEAR button twice so that “EDIT” disappears on
the display.
40