Connect manually, Redray player operation guide – RED REDRAY PLAYER User Manual

Page 22

REDRAY PLAYER OPERATION GUIDE

955-0017, REV-D | 22

2. Select Wired (Ethernet - Upper).
3. Select Automatic (DHCP).

The REDRAY communicates with the router for about 10 seconds to obtain your network IP address. You

cannot select anything on the REDRAY on-screen display during these 10 seconds.

After the REDRAY obtains the IP address, the panel on the right side of the screen closes and the IP ad-

dress displays on the NETWORK screen.
NOTE: If the REDRAY is connected to a router through an Ethernet cable and a wireless connection, two (2)

sets of IP addresses display on the NETWORK screen.

CONNECT MANUALLY

If you prefer to use a static IP address (instead of using the DHCP setting), connect to your network by follow-

ing the instructions below:
1. Navigate to SETTINGS > NETWORK.
2. Select Wired (Ethernet - Upper).
3. Select Automatic.
4. Select Manual.
5. Select IP Address and enter your network information.
6. Select Subnet Mask and enter your network information.

Wired (Ethernet - Upper)

Network IP Address