Redray setup, Set up your redray, Redray player operation guide – RED REDRAY PLAYER User Manual

Page 10

REDRAY PLAYER OPERATION GUIDE

955-0017, REV-D | 10

SET UP YOUR REDRAY

1. Install two (2) AAA batteries (included) into the IR Remote Control.
2. Attach the 802.11 Antenna (wireless transceiver) to the 802.11 Connector.
3. Connect an HDMI 1.4 cable (also known as an HDMI High Speed cable) to an HDMI input port on your moni-

tor, and connect the other end to the REDRAY port that corresponds to your monitor configuration (refer to

the table below for more information on monitor configurations):

‒ 4K (UHD) monitor: Plug an HDMI 1.4 cable into the VID D port.

‒ HD monitor: Plug an HDMI 1.4 cable into the HDTV port.

‒ Four HD monitors: Plug HDMI 1.4 cables into the VID A, VID B, VID C, and VID D ports (you will need one

(1) HDMI 1.4 cable for each port).

4. If using a standalone audio receiver, plug an HDMI 1.4 cable into the AUDIO port, and plug the other end of

the cable into an HDMI input port on your audio receiver.

5. Plug an Ethernet cable into the NETWORK port (Upper) and connect the other end to an Ethernet port on

one of the following devices:

‒ Internet router.

‒ Wireless network extender.

‒ Any other device that is designed to distribute Ethernet, such as a powerline Ethernet adapter.

NOTE: For optimal media download speeds, connect to your network using an Ethernet cable, and not a

wireless connection.

6. Plug the IEC Power Cord into the AC power connector.
7. Toggle the Power Switch to turn on the REDRAY

The POWER LED on the front panel illuminates red and the STATUS LED flashes orange.
The REDRAY powers up in about three (3) minutes.
NOTE: For more information on general setup, refer to the REDRAY QUICK-START GUIDE included.

REDRAY

SETUP