Keri Systems BioPointe Users Manual - Manual (Page 69)

Appendix A – Log Types
68
Table 3: Trace Logs
Type value Event Additional Description
Event related to the alarm indication
1
28 (1C hex) Tamper switch opened See note 1
2 29 (1D hex) Tamper switch closed See note 1
3 129 (81 hex) Activated alarm was acknowledged
and disabled The tamper switch being opened will
cause the alarm indication via the 1
st
LED to be shown. If BioPointe Central
subsequently sends a command to the
BioPointe to disable the alarm
indication, this log will be recorded.
Events related to the device powering up
4 144 (90 hex) Device powered up Recorded when the BioPointe powers
up.
5 145 (91 hex) Start-up error Recorded when there are errors during
power up.
Events related to the administration modes
6
160 (A0 hex) Administration mode was entered -
7 161 (A1 hex) Administration mode was exited -
8 178 (B2 hex) A user was added Recorded when a user is added, be it
using fingerprint, card only or card
with PIN.
If the user uses fingerprint, and enrolls
three fingerprints for the same User ID,
there will be three such consecutive
logs.
9 179 (B3 hex) A user was deleted -
10 180 (B4 hex) A master was added -
11 181 (B5 hex) A master was deleted -
Note 1: The Alarm setting must be enabled for this log to be recorded.