Keri Systems BioPointe Users Manual User Manual

Page 49

Performing Authentication with the BioPointe

Quick Search

Quick search eliminates the need for you to enter your full ID. This is useful if the number of digits
you organization used for the ID is long, making it hard for the staff to remember the full ID.

With quick search, what you need to do is to enter just 2 or more digits of your ID from the back and
then hit the first function key to initiate the matching process.

As an example, if your ID is 12345, enter ‘4’, ‘5’ followed by the key.
(The BioPointe device will perform a search for IDs ending with ‘45’.)

If any ID ending with ‘45’ is found, the sensor will light up and the 2

LED will blink fast

in red.
Place your finger on the sensor, removing it only when the sensor light goes off.

If no IDs ending with ‘45’ is found, the 1st LED lights up in red immediately.

If the 1

LED lights up in green, the authentication is successful.

If the 1

LED lights up in red, you will be allowed another try. Place your finger on the

sensor again when it lights up.