Keri Systems BioPointe Users Manual - Manual (Page 38)

Administering the BioPointe
37
Lift up your finger when you hear the
series of beep sound and place it back on
the sensor when it lights up again.
This is for the second capture.
a) If the 2
nd capture is successful, the 1 st LED will
blink green briefly as shown in 5(a). The
enrollment is successful. The 2
nd
LED will blink
fast in green next. Proceed to step 6.
b) If the 2 nd capture is not successful, the 1 st LED
will blink red briefly as shown in 5(b). The 2 nd
LED will blink fast in green next. Proceed to step
6.
Press to enroll the 2nd finger, or
to re-enroll the current 1st finger that was
not successfully done so earlier.
Or,
Press to exit.
If the # key was pressed, the 2 nd LED flashes
briefly in the color associated with the finger that
it will enroll next. The color is amber for the first
finger, green for the second finger, and red for
the third finger. Proceed to step 7.
If the * key was pressed, however, operation will
cease and return to normal mode.
Place your finger on the sensor for the 2 nd
finger enrollment when it lights up.
As before, each successful enrollment requires 2
image captures. The sensor will go off after the
first image has been successfully captured, and a
series of beep sound will be heard. Proceed to
step 8.
Lift up your finger when you hear the
series of beep sound and place it back on
the sensor when it lights up again.
Steps 7 and 8 are similar to steps 4, 5 and 6.
Repeat steps 6, 7 and 8 to enroll the 3rd
finger, or to re-enroll the current 2nd
finger if it was not successfully done so
earlier.
If the 3rd finger was successfully enrolled,
operation will cease and return to normal
mode.
5
GREEN
→AMBER
5a
5b
RED
→AMBER
2nd capture not successful.
enrollment fails.
6
AMBER GREEN
Press # to enroll 2nd finger,
or * to exit
AMBER GREEN
Press # to re-enroll 1st finger,
or * to exit
7
8
8
9
#
*