Juniper Systems Allegro 2 User Guide - Manual (Page 9)

Ch 1 Getting Started 5
3. Place the Li-Ion battery pack in the compartment.
Make sure the + and - symbols on the battery pack
label align with the symbols inside the compartment.
4. Replace the door and tighten the screws.
5. Plug the AC wall power charger that came with the
Allegro 2 into a wall socket. Plug the other end into the
DC power jack on the Allegro 2. The red LED on the
keyboard blinks when the battery pack is charging.
Attach the Hand Strap and Stylus Tether
A hand strap, capacitive stylus and tether are included with
the handheld.
Note: A stylus is not required to use the touchscreen. The
optimal way to make selections is by finger touch.
If the hand strap was not attached at the factory or you
want to move it to the other side, follow the diagram below
to attach it to the right or left side of the handheld:
One end of the stylus tether is attached to the stylus. To
attach the tether to the handheld, follow these steps:
1. Push the free tether loop through one of the tether
attachment points on the back of the handheld towards
the top.
Line up the + and - symbols
on the case and the battery
pack as shown