Juniper Systems Allegro 2 User Guide - Manual (Page 84)

80 Allegro 2 Rugged Handheld Owner’s Manual
3G Data Modem
The 3G data modem is an option for Allegro 2 Geo models,
adding Wide Area Network data modem capability. The
modem is installed at the factory.
The modem is a cellular data modem, type GSM/UMTS. It
is five band modem compatible. The modem operates in
different modes, depending on the wireless provider and
the signal strength. Data speeds vary anywhere from 10
or 20 Kbps when using GPRS to over 1 Mbps when using
HSDPA.
Set up a Data Account with a Wireless Provider
Contact a wireless provider to set up data service for the
cellular data modem and obtain an account and mini
SIM card (purchased separately). You need to provide the
following information when setting up an account:
1. Billing Information and business ID, such as your Federal
Tax I.D. or VAT number.
2. The wireless services required. Specify that you need
data service only. You do not need voice or messaging
services.
3. You may be asked for the modem’s IMEI number, which
can be found here: Start > Settings > System > System
Information > 3G Modem with the modem powered on.
4. You may be asked to provide the modem’s model
number. This number allows the carrier to verify this
modem as one of its approved models. If asked for this
by the carrier, it is a Juniper Systems Allegro 2.
Install the SIM Card
To insert or remove a card follow these steps:
1. Power off the handheld.
2. The mini SIM card slot is located in the battery
compartment. Loosen the screws to the door and
remove it.
CAUTION: Do not use a micro SIM adapter. The adapter
can get stuck and damage the slot.
!