Juniper Systems Allegro 2 User Guide - Manual (Page 31)

Ch 2 Hardware Components 27
Flashlight
Geo units have a flash LED located underneath the camera
window on the back of the Allegro 2. It can be used as a
flashlight, although its primary purpose is as a flash for the
camera.
To use the flashlight you can tap the flashlight gadget if it
is on the Home screen or press the orange + F keys. Tap
on the icon or press the keys once to turn on the brightest
illumination, again for medium brightness, and a third time
to turn it off.
SD Cards
The Allegro 2 has a slot for a micro SD card located in the
battery compartment. To insert or remove a card follow
these steps:
1. Power off the handheld.
2. Loosen the screws to the battery compartment, and
remove the door. The hand strap remains attached.
CAUTION: The Allegro 2 is not sealed against water and
dust when the battery door is not installed properly.
3. Remove the battery pack.
4. An image on the battery compartment label shows the
correct location and orientation for the SD card (slot
on the right). Push the card into the slot to insert it. To
remove the SD card, pull it out.
!