EVCO CT1SA0040101 - Manual (Page 8)

Stop leavening specifications
CT1SA0040101
Vers. 1.11
8/36
9. AUTOMATIC CYCLE
There are 7 programs available, P01… P07, and each automatic cycle consists of the following five phases:
•
stop rising
•
preservation
•
awakening
•
rising
•
slowing down
At the end of each phase, the next phase will start automatically.
When the machine is in standby mode, press the MENU key and select the AUTOMATIC menu by way of the
INCREASE and DECREASE keys, as follows:
Press ENTER to access the automatic cycle selection mode. Use the INCREASE and DECREASE keys to switch from
a program to another. The program number will be shown on the display, as follows:
Press ENTER to access the selected program-setting mode. This function is available only if parameter P69 = 1. Use
the DECREASE key to switch from one phase to another. The display will show the cycle phase and the present setpoint
values:
Press ENTER to enter the change mode; the HOUR will start blinking and you can use the INCREASE and
DECREASE buttons to change it:
Press ENTER to confirm. The number will stop blinking and you can now modify the minutes:
Press ENTER to confirm. The number will stop blinking and you can now modify the temperature:
Menu 02
Automatic
Automatic
P1
Automatic
P7
P2 Locking
04:00 - 5°C
P2 Preservation
2°C
P2 Awakening
12:30
20°C 80%
P2 Rising
12:45
30°C 80%
P2 Slowing
20°C 70%
P2 EndProg
19:45
P2 Rising
12:45
30°C 80%
P2 Rising
13:45
30°C 80%
P2 Rising
13:47
30°C 80%
P2 Rising
13:50
30°C 80%