EVCO CT1SA0040101 User Manual

Page 19

Text mode
Original mode

Stop leavening specifications
CT1SA0040101
Vers. 1.11

19/36

is the proportional adjustment band (parameter P39)

ist

is the humidification adjustment hysteresis (parameter P37)

This function is always active during the awakening, rising and slowing down phases, but it can also be enabled for the

stop and preservation phases by way of parameter P36.

Regarding the manual cycle, the humidification is only active during the heating and climatization phase.
In case the temperature in the cell is lower than parameter P31, the humidification function will be disabled.
If you are using a pot in the cell, the humidifier control time must be set in minutes and parameter P41 must be = 1.