EVCO CT1SA0040101 - Manual (Page 5)

Stop leavening specifications
CT1SA0040101
Vers. 1.11
5/36
3. GENERAL DESCRIPTION
This card provides the stop-rising cell control. Some automatic programs, a manual program and a cell pre-cooling
cycle are available.
Each automatic program consists of five phases: stop rising, preservation, awakening, rising and slowing down.
The manual program consists of three phases: cooling, heating and climatization.
4. POWER SUPPLY
When the card is on, the string “EVCO s.r.l.” will be shown for eight seconds, and then the card will go in the Off mode,
in stand-by or in a cycle mode, depending on the mode it was in when it was switched off.
The string “EVCO s.r.l.” can be replaced with a neutral string: simply set up parameter P1 = zero.
5. OFF
If the card is on Off mode, the LCD display will show the following string:
Press the ON-STANDBY key to switch the card on.
Press the MENU key to view the firmware ID for three seconds.
Regardless from the mode the card is in, by keeping the ON-STANDBY key pressed for three seconds the card will
return to the Off mode.
6. SWITCHING ON
Current date and time will be shown on the display when the card is in standby mode.
The card status after a blackout depends on parameter P10 for the automatic parameters and parameter P12 in the
case of manual programs.
The meaning of the parameter is:
P10 = 0 (P12=0): the current cycle will only resume if the duration of the blackout in question was shorter than the
value set up by way of parameter P9 (P11), otherwise the card will go in standby mode.
P10 = 1 (P12 =1): the current cycle will always start again after a blackout.
02/03/2006
Tue 17:35
OFF_