T on inizio fase t on p33 p33, Humidification with humidity probe – EVCO CT1SA0040101 User Manual

Page 18

Text mode
Original mode

Stop leavening specifications
CT1SA0040101
Vers. 1.11

18/36

T On

Inizio fase

T On

P33

Where T On is the preset number of minutes of activation.

Humidity injection is inhibited if the temperature in the cell is lower than the value determined by parameter P31 for

both the automatic and manual cycles.

18.2. Humidification with humidity probe

You can enable the humidity probe by setting parameter P32 = zero.
The humidifier output switching on/off follows the following curve.

Setpoint-zm

Setpoint-zm-ist

Setpoint

Sonda Umidità

Setpoint-zm-bp

tempo

Umidificazione

Zona a reg. Propor

Where:
Setpoint

is the preset humidity setpoint

is the dead zone for humidification (parameter P38)