Comtrol AT Command Set Rev A - Manual (Page 96)

AT Commands Reference Manual
Conexant 100722B
3-70
Reporting Supported Range of Parameter Values
Command: +DR=?
Response: +DR: ( range)
Example: +DR: (0,1)
+DR: Intermediate Result Code
The +DR: reported represents the current (negotiated or renegotiated) modem-
modem data compression type. If enabled, the intermediate result code is transmitted at
the point after error control negotiation (handshaking) at which the modem has
determined which data compression technique will be used (if any) and the direction of
operation. The +DR intermediate result code, if enabled, is issued after the Error Control
Report (+ER) and before the final result code (e.g., CONNECT).
The format of this result code is:
Result Code Syntax
+DR:
Defined Values
An alphanumeric code corresponding to the selected option:
NONE Data compression is not in use.
V42B V.42bis is in use in both directions.
V42B RD V.42 bis is in use in receive direction only
V42B TD V.42 bis is in use in transmit direction only
V44 V.44 is in use in both directions
V44 RD V.44 is in use in receive direction only
V44 TD V.44 is in use in transmit direction only
ALT MNP 5 compression.
Example
+DR: V42B