Comtrol AT Command Set Rev A - Manual (Page 219)

AT Commands Reference Manual
100722B Conexant 6-21
+VPR - Select DTE/Modem Interface Rate (Turn Off Autobaud)
This command selects the DTE/modem interface rate.
Syntax
+VPR=
Defined Values
> Decimal number corresponding to the DTE/modem interface
rate where 0 = autobaud rate determined by processing the AT
command, and 1,2,3,4,8,16,24,48,96 correspond to multipliers
of 2400 bps to determine the actual rate:
0 = Autobaud
1 = 2400 bps
2 = 4800 bps
3 = 7200 bps
4 = 9600 bps
8 = 19200 bps
16 = 38400 bps
24 = 57600 bps
48 = 115200 bps
96 = 230400 bps
Reporting Current or Selected Values
Command: +VPR?
Response:
Example: 0 For the default setting (Autobaud).
Reporting Supported Range of Parameter Values
Command: +VPR=?
Response: ( range)
Example: (0,1,2,3,4,8,16,24,48,96)
Result Codes
OK = 0,1,2,3,4,8,16,24,48,96.
ERROR Otherwise, or if not in Voice Mode.