Comtrol AT Command Set Rev A - Manual (Page 227)

S40 - General Bit Mapped Options Status.................... 3-108
S41 - General Bit Mapped Options Status.................... 3-109
S46 - Data Compression Control.................................. 3-109
S48 - V.42 Negotiation Control..................................... 3-109
S5 - Backspace Character ........................................... 3-100
S6 - Wait Time before Blind Dialing or for Dial Tone..... 3-100
S7 - Wait Time for Carrier, Silence, or Dial Tone.......... 3-100
S8 - Pause Time For Dial Delay ................................... 3-101
S86 - Call Failure Reason Code................................... 3-110
S9 - Carrier Detect Response Time.............................. 3-101
S91 - PSTN Transmit Attenuation Level....................... 3-111
S92 - Fax Transmit Attenuation Level .......................... 3-111
S95 - Extended Result Codes Control.......................... 3-111
–STE= - Set Telephony Extension ................................. 3-45
T
T - Set Tone Dial Default................................................ 3-35
V
V - Result Code Form .................................................... 3-17
\V - Single Line Connect Message Enable ..................... 3-42
W
W - Connect Message Control ....................................... 3-17
X
X - Extended Result Codes ............................................ 3-18
Z
Z - Soft Reset and Restore Profile.................................... 3-2