Comtrol AT Command Set Rev A - Manual (Page 28)

AT Commands Reference Manual
Conexant 100722B
3-2
3.2.1 Generic Modem Control
Z - Soft Reset and Restore Profile
This command causes the modem to perform a soft reset and restore (recall) the
configuration profile. If no is specified, zero is assumed.
Syntax
Z
Defined Values
Decimal number corresponding to the selected profile.
0 Soft reset and restore stored profile 0.
1 Soft reset and restore stored profile 1.
Result Codes
OK = 0 or 1.
ERROR Otherwise.
+FCLASS - Select Active Service Class
This command selects the active service class (mode).
Syntax
+FCLASS=
Defined Values
Decimal number which corresponds to the selected service
class.
0 Select Data Mode (Section 3). (Default.)
1 Select Facsimile Class 1 Mode. (Section 4).
1.0 Select Facsimile Class 1.0 Mode. (Section 4).
2 Select Facsimile Class 2 Mode. (Section 5).
8 Select Voice Mode. (Section 6).
10 Reserved.
Result Codes
OK For = 0, 1, 1.0, 2, 8, and 10 (SmartSCM only).
OK For = 0, 1, 1.0, 8, and 10 (other than SmartSCM).
ERROR Otherwise.