Comtrol AT Command Set Rev A - Manual (Page 188)

AT Commands Reference Manual
Conexant 100722B
5-16
5.4.6 +FCSI: - Report the Called Station ID
Syntax: +FCSI: “” Called Station ID
This response reports the received called station ID string, if any. This message is
generated in execution of Originate, Answer, +FDT, or +FDR commands.
5.4.7 +FPTS: - Receive Page Transfer Status
Syntax: +FPTS:, [,, ]
The +FPTS: is generated by the DCE at the end of Phase C data reception in
execution of a +FDR command.
The is generated by the DCE; it depends on the DCE capabilities at T.4 error
checking. See Table 5-4 for values.
The receiving DCE will count the lines. These values are;
= line count
=
A receiving DTE may inspect and write a modified value into the +FPTS
parameter. The DCE will hold the corresponding Post Page Response message until
released by a +FDR command from the DTE.
5.4.8 +FET: - Post Page Message Response
Syntax: +FET:
The +FET: response is generated by a receiving DCE after the end
of Phase C reception on receipt of the post-page message from the transmitting station.
The +FET: response is generated in execution of a +FDR command. The
codes respond to the T.30 post page messages (Table 5-3).
5.4.9 +FPTS: - Transmit Page Transfer Status
Syntax: +FPTS:
The +FPTS: response reports a number representing the copy quality and related
post-page message responses received from the remote DCE. The valid values are
defined in Table 5-4.
The +FPTS: response is generated in execution of a +FET= command.