Comtrol AT Command Set Rev A - Manual (Page 71)

AT Commands Reference Manual
100722B Conexant 3-45
–STE= - Set Telephony Extension
The –STE command enables/disables Line-In-Use, Extension Pickup, and Remote
Hangup detection features.
Note: Additional hardware may be required to support these features.
Syntax
-STE=
Defined Values
Decimal number corresponding to the selected bit-mapped
options. The bit fields are defined as follows:
Bit 0 Line-In-Use detection enable/disable.
Bit 1 Extension Pickup detection enable/disable.
Bit 2 Remote Hangup detection enable/disable.
(Dec.)
Remote
Hangup Extension
Pickup
Line-In-Use
0 (default) Disabled Disabled Disabled
1 Disabled Disabled Enabled
2 Disabled Enabled Disabled
3 Disabled Enabled Enabled
4 Enabled Disabled Disabled
5 Enabled Disabled Enabled
6 Enabled Enabled Disabled
7 Enabled Enabled Enabled
Reporting Current or Selected Values
Command: -STE?
Response: -STE:
Example: -STE: 4 Remote Hangup enabled, Extension
Pickup disabled, and Line-In-Use
disabled.
Reporting Supported Range of Parameter Values
Command: -STE=? Show available options.
Response: -STE: 0-7
Result Codes
OK = 0-7
ERROR Otherwise.
Behavior in Data Mode (+FCLASS=0)
When on-hook, if the line is in use and an ATDT is issued, the modem will not go off-
hook and will return with the message LINE-IN-USE.