Comtrol AT Command Set Rev A - Manual (Page 177)

AT Commands Reference Manual
100722B Conexant 5-5
5.1.5 Identification of T.30 Options
Group 3 devices negotiate session parameters in DIS, DCS, and DTC frames. These
parameters are defined in Table 5-2.
5.1.6 Session Status Reporting
The DCE provides reports to the DTE on the status of a session. The DCE provides the
following status reports:
1. Connection and hang up status:
+FCON
+FHNG:<0-255>
2. Requested DIS session parameters +FDIS: reports remote facsimile
capabilities.
Syntax: +FDIS: VR, BR, WD, LN, DF, EC, BF, ST
3. +FDCS: reports the negotiated parameters
4. Phase C prompts:
XON, XOFF, DC2
5. Phase C base status reports: depending upon copy quality and related end-of page
status:
+FPTS: <1-5>
5.1.7 Procedure Interrupt Negotiation
CCITT allows a station to request a procedure interruption at the end of a page. This
request is passed between stations by the PIP, PIN, and PRI-Q messages.
5.2 Service Class 2 Identification and Selection
Three commands report identification and selection information. Each of these three
commands cause the DCE to send a message to the DTE. The messages are
programmable using ConfigurACE.
5.2.1 +FMFR? - Request Manufacturer Identification
The +FMFR? command causes the DCE to send a message identifying the DCE product
manufacturer. The default message is:
CONEXANT
OK
5.2.2 +FMDL? - Identify Product Model
The +FMDL? command causes the DCE to send a message identifying the DCE product
model.