Comtrol AT Command Set Rev A - Manual (Page 122)

AT Commands Reference Manual
Conexant 100722B
3-96
-QCPC - Force Full Startup Procedure Next Connection
This command causes the modem to use full startup procedures on the next connection
attempt regardless of the setting of the +PQC command. After this attempt, the modem
will select the startup procedure as defined by the +PQC command. If a shortened startup
procedure is enabled by the +PQC command, then the quick connect profile will also be
updated on the next connection attempt.
Syntax
-QCPC
Result Code
OK In V.92 Mode (+MS=V.92)
ERROR Otherwise
-QCPS - Enable Quick Connect Profile Save
This command controls whether or not the modem will save the generated quick connect
profile.
Syntax
-QCPS=
Defined Values
Decimal number corresponding to the desired operation.
0 Do not allow the quick connect profile to be
saved.
1 Allow the quick connect profile to be saved.
(Default.)
Result Codes
OK 0 or 1 in V.92 Mode (+MS=V.92) and quick connect is
enabled (+PSS = 0)
ERROR Otherwise
Reporting Selected Value(s)
Command: -QCPS?
Response: -QCPS:
Example: -QCPS: 1 For the default setting.
Reporting Supported Range of Parameter Values
Command: -QCPS=?
Response: -QCPS: ( range)
Example: -QCPS: (0,1)