Comtrol AT Command Set Rev A - Manual (Page 209)

AT Commands Reference Manual
100722B Conexant 6-11
+VLS - Analog Source/Destination Selection
This command causes the modem to select one or more source/destinations of the analog
data.
Syntax
+VLS=
Defined Values
Decimal number corresponding to the selected analog
source/destination hardware configuration (see Table 6-5).
Command: +VLS?
Response:
Example: 0 For the default setting.
Reporting Supported Range of Parameter Values
Command: +VLS=?
Response: ,,,,
Where each event subparameter is a hex number the represents an event bit field of the
reporting capabilities of each state. (see Table 6-6):
Identifies the modem analog source/destination hardware
configuration
A made up of Primitives,
, , and event>subparameters are the DCE event reporting capabilities
for the Voice Transmit State, Voice Receive State, and the
Voice Command State, respectively. Each of the event
reporting subparameters is a hex number that represents an
event bit field. The hex number format is defined in Table
6-6); a one in the bit field indicates that the DCE can report
the associated event.
Each of the possible hardware configurations has its own , ...,
description line (the above form description shows just one). A terminates
each description line.
Example: AT+VLS=?
0,"",B0804100,B0804100,B0804100
1,"T",0B8433C1,0FE431C1,0B8431C1
2,"L",08800300,0CE00100,08800100
3,"LT",0B8433C1,0FE431C1,0B8431C1
4,"S",00800300,04E00100,20800100
5,"ST",0B8433C1,0FE431C1,0B8431C1
8,"S1",00800300, 04E00100,20800100
9,"S1T",0B8433C1,0FE431C1,0B8431C1
11,"M1",00800300,04E00100,20800100
14,"H",00800300,04E00100,20800100
18,"M1S",00800300,04E00100,20800100
19,"M1S1",00800300,04E00100,20800100