Comtrol ES8510-XT User Manual
Page 157
RocketLinx ES8510 and ES8510-XT User Guide: 2000513 Rev. H
VLAN (CLI) - 157
Configuration Using the Command Line Interface (CLI)
VLAN Port Configuration (continued)
Display – Port
Egress Rule (Egress
rule, IP address,
status)
Switch# show running-config
……
!
interface fastethernet1
switchport access vlan 1
switchport access vlan 3
switchport trunk native vlan 2
…….
interface vlan1
ip address 192.168.250.8/24
no shutdown
VLAN Configuration
Create VLAN (2)
Switch(config)# vlan 2
vlan 2 success
Switch(config)# interface vlan 2
Switch(config-if)#
Note: In the CLI configuration, you should first create a VLAN interface. Then you can
start to add/remove ports. The default status of the created VLAN is unused
until you add member ports to it.
Remove VLAN
Switch(config)# no vlan 2
no vlan success
Note: You can only remove the VLAN when the VLAN is in unused mode.
VLAN Name
Switch(config)# vlan 2
vlan 2 has exists
Switch(config-vlan)# name v2
Switch(config-vlan)# no name
Note: Use no name to change the name to default name, VLAN VID.
VLAN description
Switch(config)# interface vlan 2
Switch(config-if)#
Switch(config-if)# description this is the VLAN 2
Switch(config-if)# no description ->Delete the description.
IP address of the
VLAN
Switch(config)# interface vlan 2
Switch(config-if)#
Switch(config-if)# ip address 192.168.250.18/24
Switch(config-if)# no ip address 192.168.250.8/24 ->Delete the IP
address
Create multiple
VLANs (VLAN 5-8)
Switch(config)# interface vlan 5-8
Shutdown VLAN
Switch(config)# interface vlan 2
Switch(config-if)# shutdown
Switch(config-if)# no shutdown ->Turn on the VLAN