Comtrol ES8510-XT User Manual
Page 146
146 - Port Configuration (CLI)
RocketLinx ES8510 and ES8510-XT User Guide: 2000513 Rev. H
Configuration Using the Command Line Interface (CLI)
Rate Control
Rate Control
– Ingress or
Egress
Switch(config-if)# rate-limit
egress Outgoing packets
ingress Incoming packets
Note: To enable rate control, you should select the Ingress or Egress rule first; then assign the
packet type and bandwidth.
Rate Control
– Filter
Packet Type
Switch(config-if)# rate-limit ingress mode
all Limit all frames
broadcast Limit Broadcast frames
flooded-unicast Limit Broadcast, Multicast and flooded unicast frames
multicast Limit Broadcast and Multicast frames
Switch(config-if)# rate-limit ingress mode broadcast
Set the ingress limit mode broadcast ok.
Rate Control
– Bandwidth
Switch(config-if)# rate-limit ingress bandwidth
<0-100> Limit in megabits per second (0 is no limit)
Switch(config-if)# rate-limit ingress bandwidth 8
Set the ingress rate limit 8Mbps for Port 1.
Port Trunking
LACP
Switch(config)# lacp group 1 gi
Group 1 based on LACP(IEEE
802.3ad) is enabled!
Note: The interface list is gi8. Ports with a different speeds cannot be aggregated together.
Static Trunk
Switch(config)# trunk group 2 fa6-7
Trunk group 2 enable ok!
Display –
LACP
Switch# show lacp internal
LACP group 1 internal information:
LACP Port Admin Oper Port
Port Priority Key Key State
----- ----------- -------- -------- -------
8 1 8 8 0x45
9 1 9 9 0x45
10 1 10 10 0x45
LACP group 2 is inactive
LACP group 3 is inactive
LACP group 4 is inactive