Comtrol UP DeviceMaster Installation - Manual (Page 74)

74 - Hardware Specifications Hardware Installation and Configuration Guide: 2000451 Rev. J
Hardware Specifications
External Power Supply Specifications
This subsection discusses information that you may need if you wish to use your
own external power supplies.
• 1-Port on Page 74
• 2-Port (Serial Terminals) on Page 74
• 2-Port (DB9) on Page 75
• 4-Port on Page 75
1-Port This table provides specifications for the power
supply shipped with the DeviceMaster UP 1-
port.
This table provides the specifications, if you
intend on using your own power supply.
2-Port (Serial
Terminals) This table provides the specifications to purchase a power supply for a
DeviceMaster UP 2-port 1E/2E model with serial terminal connectors.
Comtrol Power Supply: 1-Port 5-30VDC
Input line frequency
Input line voltage
Output voltage
Output current
43-63 Hz
90-260 VAC
24VDC
500 mA @ 24VDC
External Power Supply: 1-Port 5-30VDC
Output voltage†
Current†
Power
5-30VDC
100 mA (Min) @ 24VDC
2.5 W
† Any power supply that meets current consumption, voltage,
power, and connector pinouts requirements can be used.
Earth Gnd
Return
Positive
5-30VDC
+
-
Wire gauge:
AWG 12-22
Screw Terminal Connector
External Power Supply: 2-Port
(Serial Terminal Connectors) 5-30VDC
Output voltage†
Current†
Power
5-30VDC
100 mA (Min) @ 24VDC
2.5 W
† Any power supply that meets current consumption, voltage,
power, and connector pinouts requirements can be used.
Signal
Ground†
Chassis
Ground†
Positive† Return†