beautypg.com

Mounting the embedded – Comtrol UP DeviceMaster Installation User Manual

Page 17

background image

Hardware Installation and Configuration Guide: 2000451 Rev. J

Hardware Installation - 17

Hardware Installation

Mounting the
Embedded

Use the following procedure to mount the DeviceMaster UP 1-Port Embedded with
the 5-30VDC power supply.

Observe proper ESD techniques when handling the DeviceMaster UP.

1.

Carefully remove the DeviceMaster UP from the anti-static bag, following
standard electrostatic device handling procedures.

2.

Mount the DeviceMaster UP for your environment using 1/4” stand-offs to
separate the DeviceMaster UP from the base.

3.

Use one of the following methods to ground the DeviceMaster UP.

Through the power supply by connecting the ground wire on the power
cable using plastic or metal stand-offs.

Through the chassis, using metal stand-offs. If plastic stand-offs are used
to mount the board, then you must ground the DeviceMaster UP using the
power cable.

Note: The maximum diameter of the metal stand-offs should be 0.175” with a

4-40 machine screw. Metal stand-offs are not provided with the
DeviceMaster UP.

4.

Optionally, attach the light pipes. The following light pipes have been tested
and found to function; Bivar, Inc. (P/N:LP-230) and Ledtronics, Inc.

(P/N:LTP003-0CW-001).

Caution

Non‐plated/non‐grounded mounting holes 0.116” diameter (+/‐0.003”). 

WARNING: Holes in hatched area are not mounting holes.

     Maximum component height above board is 0.55”.

Ethernet connection J2: J2 overhangs board edge by 0.14” and the height is 0.55”.

 

LED light pipe mounting holes. The LED light pipes are not provided. 

Serial port connector J3: 0.1” pin spacing, 0.025” square pin diameter, and 0.230” 

pin height. 
Debug port connector J4: 0.1” pin spacing, 0.025” square pin diameter, and 0.230”

     Power connector; the mating connector is Weidmuller P/N: 152651.

1

3

4

5

6

7

8

9

Plated/chassis grounded mounting hole 0.116” diameter (+/‐0.003”). 

2

pin height.

5-30VDC Model

        

Caution