Comtrol UP DeviceMaster Installation - Manual (Page 31)

Hardware Installation and Configuration Guide: 2000451 Rev. J Configuring the DeviceMaster UP - 31
Configuring the DeviceMaster UP
9. Click Launch PortVision DX and Finish in the last installation screen.
10. Depending on the operating system, you may need to click Yes to the Do you
want to allow the following program to make changes to this computer? query.
11. Select the Comtrol Ethernet-attached products that you want to locate and
then click Scan.
Note: If the Comtrol Ethernet-attached product is not on the local segment
and it has been programmed with an IP address, it will be necessary to
manually add the Comtrol Ethernet-attached product to PortVision DX.
12. Go to Step 5 in the next section, Configuring the Network Settings, to program
the DeviceMaster UP network settings.
If you need additional information about PortVision DX, refer to the Help system.
You can save time if you only scan for DeviceMaster